How to Animate a Bouncing Ball with Squash and Stretch
Squash the ball on the frame it touches the ground. Stretch it just after liftoff, make each rebound lower than the last, and return the ball to a circle at rest.
Block the bounce with one fixed ground line
Draw a horizontal ground line and keep the ball’s horizontal position fixed. Measure the gap from the bottom of the ball to the line. If your tool positions the ball by its center, set the center at the gap plus half the ball’s height above the line. These are practice values, not measurements from the Loretry preview.
| Frame | Pose | Width × height (units) | Gap above ground (units) |
|---|---|---|---|
| 1 | Drop start | 100 × 100 | 180 |
| 12 | First contact | 125 × 80 | 0 |
| 13 | First liftoff | 80 × 125 | 12 |
| 21 | First peak | 100 × 100 | 90 |
| 29 | Second contact | 112 × 90 | 0 |
| 30 | Second liftoff | 90 × 112 | 8 |
| 35 | Second peak | 100 × 100 | 35 |
| 40 | Final contact | 105 × 95 | 0 |
| 41 and 45 | Rest | 100 × 100 | 0 |
At 24 frames per second, set the listed poses as keyframes. Start with linear interpolation between poses. Keep the squash on the contact frame: if the ball already looks flat one frame before impact, add a round pose on that earlier frame and keep a small gap above the line.
Check the contact frame before adjusting timing
Step through each landing. The ball’s bottom edge should meet the line without crossing it. At first contact, the center should be 40 units above the line. Compare the two peaks using the bottom edge: the second should be 35 units above the line, below the first at 90. From frame 41 through 45, the ball should stay round and still on the line.
Compare with a Loretry reference
Open the Bounce, Squash and Stretch Skill reference. The Skill page describes four stages: Drop, Contact, Rebound, and Settle.